40 lines
2.3 KiB
Markdown
40 lines
2.3 KiB
Markdown
Hello! I have written a v2 usermod for the BME280/BMP280 sensor based on the [existing v1 usermod](https://github.com/Aircoookie/WLED/blob/master/usermods/Wemos_D1_mini%2BWemos32_mini_shield/usermod_bme280.cpp). It is not just a refactor, there are many changes which I made to fit my use case, and I hope they will fit the use cases of others as well! Most notably, this usermod is *just* for the BME280 and does not control a display like in the v1 usermod designed for the WeMos shield.
|
|
|
|
- Requires libraries `BME280@~3.0.0` (by [finitespace](https://github.com/finitespace/BME280)) and `Wire`. Please add these under `lib_deps` in your `platform.ini` (or `platform_override.ini`).
|
|
- Data is published over MQTT so make sure you've enabled the MQTT sync interface.
|
|
- This usermod also writes to serial (GPIO1 on ESP8266). Please make sure nothing else listening on the serial TX pin of your board will get confused by log messages!
|
|
|
|
To enable, compile with `USERMOD_BME280` defined (i.e. `platformio_override.ini`)
|
|
```ini
|
|
build_flags =
|
|
${common.build_flags_esp8266}
|
|
-D USERMOD_BME280
|
|
```
|
|
or define `USERMOD_BME280` in `my_config.h`
|
|
```c++
|
|
#define USERMOD_BME280
|
|
```
|
|
|
|
Changes include:
|
|
- Adjustable measure intervals
|
|
- Temperature and pressure have separate intervals due to pressure not frequently changing at any constant altitude
|
|
- Adjustment of number of decimal places in published sensor values
|
|
- Separate adjustment for temperature, humidity and pressure values
|
|
- Values are rounded to the specified number of decimal places
|
|
- Pressure measured in units of hPa instead of Pa
|
|
- Calculation of heat index (apparent temperature) and dew point
|
|
- These, along with humidity measurements, are disabled if the sensor is a BMP280
|
|
- 16x oversampling of sensor during measurement
|
|
- Values are only published if they are different from the previous value
|
|
- Values are published on startup (continually until the MQTT broker acknowledges a successful publication)
|
|
|
|
Adjustments are made through preprocessor definitions at the start of the class definition.
|
|
|
|
MQTT topics are as follows:
|
|
Measurement type | MQTT topic
|
|
--- | ---
|
|
Temperature | `<deviceTopic>/temperature`
|
|
Humidity | `<deviceTopic>/humidity`
|
|
Pressure | `<deviceTopic>/pressure`
|
|
Heat index | `<deviceTopic>/heat_index`
|
|
Dew point | `<deviceTopic>/dew_point` |