Sternenlabor/nuki_hub
2
0
Fork 0
Code Issues Pull Requests Actions Packages Projects Releases Wiki Activity

update readme

Browse Source
This commit is contained in:
technyon
2022-06-30 21:24:27 +02:00
parent 42cb90a040
commit eb05c1f697
11 changed files with 71 additions and 57 deletions
Download Patch File Download Diff File Expand all files Collapse all files

16
README.md
View File

@@ -20,7 +20,7 @@ The firmware uses the Wifi Manager to configure the WiFi network. Power up the E
After configuring the Wifi, the ESP should automatically connect to your network. Use the web interface to setup the MQTT broker; just navigate to the IP-Address assigned to the ESP32 via DHCP (often found in the web interface of the internet router).<br>
To configure MQTT, enter the adress of your MQTT broker and eventually a username and a password if required. The firmware supports SSL encryption for MQTT, however most people and especially home users don't use this. In that case leave all fields about "MQTT SSL" blank.
## Paring
## Pairing
Just enable pairing mode on the NUKI lock (press button for a few seconds) and power on the ESP32. Pairing should be automatic. When pairing is successful, the web interface should show "Paired: Yes" (reload page in browser). MQTT nodes like lock state and battery level should now reflect the reported values from the lock.
@@ -110,6 +110,20 @@ W5x00 reset to GPIO33
Wifi is now disabled, and the module doesn't boot into WifiManager anymore.
## Troubleshooting
### Random WiFi disconnects
Unfortunately the ESP32 has problems with some Access Points and reconnecting fails.
As a workaround you can navigate to "MQTT and Network Configuration" and enable "Restart on disconnect".
This will reboot the ESP as soon as it gets disconnected from WiFi. Also, this reduces
the config portal timeout to three minutes to prevent the ESP being stuck in config
mode in case an access point is offline temporarily.
### Authorization data isn't published
Reading the authorization data from the access log is protected by the configured PIN.
If you don't get any published data try setting the PIN or try reentering it to make
sure it's correct.
## Disclaimer
This is a third party software for NUKI smart door locks. This project or any of it's authors aren't associated with Nuki Home Solutions GmbH. Please refer for official products and offical support to their website: